#3 DVD Video Secrets in Metal shaping Bead Roller"

In this video, Lazze reveals his techniques in metal shaping utilizing his distinctive bead roller.

This instructional video is applicable to any bead roller. By configuring the dies in a similar manner, you can achieve the same results. Lazze commences the video by guiding you through a step-by-step process to gain mastery over the sheet metal. He introduces four fundamental elements that will transform your perspective on metal shaping. It is essential to remember that in metal shaping, you can perform four actions: cutting, bending, shrinking, and stretching. By combining one or more of these actions, you can effectively manipulate the sheet. If you follow his instructions precisely, you are guaranteed to achieve the same outcomes. As you begin to take control of the sheet, you will develop the skills necessary for metal shaping, enabling you to create any design you envision from a flat sheet of metal.

Table of Contents
Chapter 1 : How to use the guide: how to bend an outer curve or a straight edge 10:30 min
Chapter 2 : How you can bend an inner curve, like a flange 6:30
Chapter 3 : How you can make a sub-frame for a '33 Ford 3:32
Chapter 4 : How you can make a fender flare for a '36 Ford or similar fender edge 9:41
Chapter 5 : How you can make a tapered bead 13:02
Chapter 6 : How you can easily make a patch panel for a car 3:14
Chapter 7 : How you can make a wide bead, up to any width you want 1:49
Chapter 8 : How you can make a nice wide bead, but not too deep 5:43
Chapter 9 : How to make flames on a panel or a hood side for a car 6:51
Chapter 10 : How to make flames, continued 8:35
Chapter 11 : How you can work on both sides of the bottom die in the bead roller 1:49
Chapter 12 : How you can use two flat dies in the bead roller as a stretcher 1:56
Chapter 13 : How you can make a door jam on a car bent in a z-profile 7:37
Chapter 14 : How you can bend a panel up to 90 degrees and then 45 degrees more 6:26
Chapter 15 : How you can make a crisp step in a panel 2:20
Chapter 16 : How you can make a wire edge for a patch panel for a '32 Ford fender 12:38
Chapter 17 : How you can make hundreds of new profiles with a skateboard wheel 6:29
Chapter 18 : More skateboard wheel tricks 1:44
Chapter 19 : More skateboard wheel tricks (II) 5:46
Chapter 20 : More skateboard wheel tricks (III) 1:45
Chapter 21 : More skateboard wheel tricks (IV) 2:16
Chapter 22 : How you can make a Z-profile in a door frame 8:40