LAZZE Metal Shaping
Home
Products
New Items
Hands on Classes
Free Videos
Photo Gallery
Featured Articles
Testimonials
About Lazze
Site Search
Contact Us
  



#3 DVD Video Secrets in Metal shaping Bead Roller


From Lazze Inc.
Click to ZOOM!
#3 DVD Video Secrets in Metal shaping Bead Roller

On this video Lazze shows you his Secrets in Metal Shaping when he uses his unique Bead Roller.

  • This video can be used for any bead roller.

If you set up the dies the same way you can do the same thing. He begins this video by teaching you, in a Step-by-Step fashion, how you can take control over the sheet. There are four elements that are going to change the way you look at metal shaping. Remember, in metal shaping you can do four things, you can cut, bend, shrink and stretch, when you do one or more of those four elements in combination you can control the sheet. If you do exactly as he shows you on these videos, you will have the same result, that’s for sure and it’s a guaranty. When begin to take control over the sheet you begin to master the skills of Metal shaping and you will be able to create anything you want from a flat sheet of metal.

Table of Contents
Chapter 1 : How to use the guide: how to bend an outer curve or a straight edge 10:30 min
Chapter 2 : How you can bend an inner curve, like a flange 6:30
Chapter 3 : How you can make a sub-frame for a '33 Ford 3:32
Chapter 4 : How you can make a fender flare for a '36 Ford or similar fender edge 9:41
Chapter 5 : How you can make a tapered bead 13:02
Chapter 6 : How you can easily make a patch panel for a car 3:14
Chapter 7 : How you can make a wide bead, up to any width you want 1:49
Chapter 8 : How you can make a nice wide bead, but not too deep 5:43
Chapter 9 : How to make flames on a panel or a hood side for a car 6:51
Chapter 10 : How to make flames, continued 8:35
Chapter 11 : How you can work on both sides of the bottom die in the bead roller 1:49
Chapter 12 : How you can use two flat dies in the bead roller as a stretcher 1:56
Chapter 13 : How you can make a door jam on a car bent in a z-profile 7:37
Chapter 14 : How you can bend a panel up to 90 degrees and then 45 degrees more 6:26
Chapter 15 : How you can make a crisp step in a panel 2:20
Chapter 16 : How you can make a wire edge for a patch panel for a '32 Ford fender 12:38
Chapter 17 : How you can make hundreds of new profiles with a skateboard wheel 6:29
Chapter 18 : More skateboard wheel tricks 1:44
Chapter 19 : More skateboard wheel tricks (II) 5:46
Chapter 20 : More skateboard wheel tricks (III) 1:45
Chapter 21 : More skateboard wheel tricks (IV) 2:16
Chapter 22 : How you can make a Z-profile in a door frame 8:40
 

Item
1_102
#3 DVD Video Secrets in Metal shaping Bead Roller / Each

Quantity:   Only  $129.00
Here are some other items you may be interested in:

Facebook Linkedin Twitter YouTube
Share